Citroën Registry

58531 Repair Manual (CX) | Page 397

Citroën Repair Manual
CX Vehicles, Mechanical Components 1
N°058531, September 1988
SECTION OVERVIEWRemove/fit anti-roll bar
Remove/fit anti-roll bar, page 397 of 611 — CX Repair Manual — Mechanical Components 1
Page ↔ Forum
Start a discussion
Find related SP-6
58531 · p.397
REPRESENTATIVE EXCERPT — FOR REFERENCE ONLY (from p.398)

Centre the automatic height control sideways in the height corrector ball-joint to prevent the slide valve from being stressed. Tighten the automatic height control clamp to 1.5 mdaN. Remove tools 6301-T and 6301-T bis. Refit, Fig. Il: - the height corrector protection casing (4), - the exhaust shield (5). Attach the brake control valve. Tighten the screws to 1.8 mdaN, equipped with contact washers. Reposition: - the rubber seals, - the wheels. Lower the vehicle to the ground. Check the front heights. Adjust if necessary. (See MA @) 430.00/1).

Vehicle Application: Citroën CX 20 · CX 22 · CX 25 · September 1988