58531 Repair Manual (CX) | Page 424

Start screwing in by hand connecting nuts (4), (8) and (10) and feed pipe union nuts (5 and 9) provided with NEW sleeve seals. Tighten: - the three nuts «a» securing hydraulic control unit to its bracket, to 0.8 mdaN, - the connecting nuts. Recouple return pipe (6). Reconnect wiring harness (7). Refit, Fig.I : - trim cover (3), - screws (2). Clip the assembly in place on the control block. Recouple the power cable with the centrifugal regulator. Bleed the brakes: Apply the same procedure as for non A.B.S. vehicles. (See @ MA 453.0/1).