58531 Repair Manual (CX) | Page 386

- the suspension cylinder. REFITTING Check that the suspension cylinder dust-guard contains LHM fluid. If this is not the case, fill with 7 cc. of fluid. Fit the suspension cylinder and thrust race (4). Recouple feed pipe (5) (equipped with a NEW sleeve seal, Fig. Il). Reinstall: - clip (6), Fig. U, - the sphere whose contact face «a» has been Slightly lubricated, fitted with a NEW seal. - tighten by hand. Couple up, Fig. |: - overflow return pipe (1), - venting pipe (2). Insert pin (3), Fig. |. Start the engine. Check the circuit for leaks. Replace the road wheel. Lower the vehicle to the ground.