818 Repair Manual (CX) | Page 38

Supplement No. 1 to Manual 818-1 (ADD) « PALLAS » and « ADMINISTRATION » type 1. Fitting the lower body-shell finishing strips : Position the inner : front, and rear. The clearance between each embellisher must not exceed 5 mm. Mark and punch the eight fixing holes using a pin-punch, and fit the round headed self-tapping screws. Tighten them. Position the outer mark and punch each fixing hole using a pin-punch, and fit the self-tapping fixing screws. Tighten them. 2. Fitting the bumper and protective pads : Fit the protective pads, and-secure them using nuts and contact washers. ‘ 1