14 1S 16 17 18 18. Position front linkage rod (6) correctly in 22. Adjust the lateral position of the front torsion rods. to relay lever (9). The end piece (1) of the rod must be within 1 mm ar approximately in the of the holes in the arm Determine in the rod the corresponding hole body. ; = +1 . «a» to obtain a clearance j = 7,5 7 4° =m. If necessary, move the rod after loosening clamp ( 12) If no adjustment is possible by using the 23. Adjust the lateral position of the rear torsion rods holes in the rod (6) move the quadrant end-piece (18) must be parallel to the body in its slots. 19.